When tungsten steel milling cutters are produced and processed, tungsten steel milling cutters need to be used as auxiliary parts for processing, so how to correctly install tungsten steel milling cutters and milling heads can maximize the performance of the equipment.
Let's answer this question in detail below.
1. Put the milling head of the
Tungsten Steel Milling Cutter on the milling card, hold the toothless part of the milling head with one hand, and place the milling card on the milling card without falling off;
2. Use the hand holding the milling head to press the round button next to the milling head column, and continue to twist the nut with the other hand until it is tightened. Remember not to use too much force and be careful of your hands being scratched;
3. When you are processing, you must install the tungsten steel milling cutter well. If the installation method is not in place or the incorrect installation method is used, the processing will be interrupted or the processing efficiency will not be high. Also choose the appropriate tungsten steel milling cutter, the processing efficiency will be better.
In addition to paying attention to the correct installation method of the tungsten steel milling cutter head, it is also very important to choose the right tungsten steel milling cutter.
